These DIY sock blockers are so handy and easy to make. I used the pattern by Janet Ballweber found at http://www.cyberseams.com and used vinyl cutting boards that I picked up at Winner’s. I used a sharpie to mark it and a mix of a rotary cutter and scissors to cut the forms out. I used sand paper and a Dremel to clean the edges, but the sandpaper was honestly better for the job. The Dremel sent little bits flying and caused more clean-up than expected. A great money saver! The pre-cut hole in the cutting board will make hanging the socks to dry on the blockers so simple.